imrishabh18/rp2040-motor-controller

Bottom-side PCB silkscreen artwork implementing mirrored tsCircuit logos as embedded SVG paths, with via-clearance-aware placement and no active electronics.

Version
1.0.41
License
unset
Stars
5

routing/README.md

# Saved PCB routing

`route-plan.json` contains the validated routes and the exact geometry/connectivity input for core 0.0.2032. `saved-routing.ts` supplies these routes through the local routing algorithm interface; core regenerates the copper, vias and ground pours and runs its normal checks.

The input guard rejects changed pads, placement, connectivity or rules. Regenerate and recheck routes after a PCB change; do not bypass this guard by merely replacing `expectedInput`.

The current repair shortens decoupling routes and resolves the newer checker's trace and via-clearance findings. All eleven motor-current nets remain on outer layers. `ground-pour-selection.json` retains all 28 regions in the audited four-layer ground network. The low-current Q_STATUS_B ground return uses an inner-layer link.

Run `bun run verify` and the independent copper/export audits before fabrication. The current results and exact artifact hashes are in [the routing review](../reports/routing-refresh-review.md). No checker, manufacturing rule or regression threshold was relaxed.

Use `bun run dev --port 3020` for the current CLI viewer. Its rendered copper was compared with the CLI output and matches.